The Universal Wheel Kit protects your floors and makes traveling with your dog's plastic crate effortless. Fits most large breed plastic kennels. Kit includes two pivoting wheels for the front and two stationary wheels for the back. Just slide wheels in and snap over ridge to secure. Wheels are easily removable. Manufacturer offers a limited one year warranty. Installation Instructions To complete this installation, you must be able to reach the lower rear corners of the kennel from the inside and outside at the same time. Because of this, Petmate recommends performing the installation with the kennel top separated from the kennel bottom. Required Tools not included Small scissors A drill with a 14 drill bit A 2 Phillips head screwdriver An 8 mm or 516 wrench or an adjustable wrench Parts Included 4x Wheel Assemblies 4x Mounting Brackets 4x Bolts 4x Reinforcement Bars 4x Lock Washers 4x Nuts Step 1 Place the bottom half of the kennel bottom upwards on a sturdy surface that is low enough to allow easy access for drilling the mounting holes. Step 2 Using scissors, cut out the four wheel mounting bracket templates. Step 3 Position template in each corner of the kennel making sure it is oriented with the tab facing inward and on a flat surface. Using tape, secure template in place. Repeat for three remaining templates. Note It is very important to position templates properly. Back wheel must be in a straight line with front wheel to roll properly. Step 4 Using a 14 drill bit, drill all 16 of these holes directly through the paper and the kennel bottom. Start each hole carefully to make sure the drill bit does not pull to the side, away from the correct hold location. Step 5 Remove this template from the kennel. Step 6 Using a Phillips head screwdri
